Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

If you sell to woodworkers, your customers are already here

Tool making tip

Posts

Tool making tip

#1

Steven Antonucci

Tool making tip

steven antonucci

In reading Brad's post below about the tool handle coming lose in a demo and the tool spinning in the handle, I thought I'd share what I started doing on the tools I make.

I used to glue them with CA or epoxy, but if you are turning handles from green wood, sometimes the CA will cure from the moisture before you can get the tool fully inserted. Epoxy seems to not want to stick too well.

For starters, I drill my hole 1/64th small if I can. My lathe won't drill an accurate hole to the exact diameter of the steel anyway, so slightly undersized makes for a pretty good fit. If the tool is an offset cutting tool (i.e. cutter in a hollowing tool or swan neck...), I grind a very small spur on the end that is going into wood, and I seat it with a mallet. 1/8" is plenty, and it doesn't need to be perfect like a spur center- it just has to engage the end grain.

Steve

Re: Tool making tip

#2

Re: Tool making tip

Jennifer Indy.USA

Steve, I'm not sure I'd make tool handles out of green wood. You might be making for troubles down the road.

Just my measly two cents :)

Jen

Re: Tool making tip

#3

Steven Antonucci

Short of black hands, no issues

steven antonucci

Green or otherwise, the spur really helps with offset cutters.

When I process a log for face grain blanks (like a bowl), I saw out the middle slab where the pith is. After that slab is out, I saw the pith out of the slab, leaving me 2 quartersawn pieces just slightly less than half the width of the log. Since they are quartersawn, they really don't move much at all. Also, wood shrinks as it dries, so they really grip the steel (even sort of rust/seizing to the wood).

The only downside is that if you have a wood like oak or cherry with a high tanin concentration, your hands turn blank from holding the handles (which I never put a finish on any more). Lemon juice gets the tanin stains uout and also lets you know where you cut yourself on any particular day.

Steve

Re: Tool making tip

#4

Re: Tool making tip

john lucas

I turn my tool handles out of dry wood. I drill a hole a little undersize. I grind a slightly square shape to the very end of the tang. Then I heat this end red hot or close. I let it cool slightly and then drive it in the handle. This really locks the wood into the handle.

Re: Tool making tip

#5

Re: Tool making tip

Bill Turpin in WNC mountains

I drill a hole that allows a comfortable fit. I then "waller" the inside with a dremel ball bit. I cut nicks in the corners of the steel with the edge of my grinder wheel, then fill the space with five minute epoxy. The resulting plug is bigger than the exit hole. It will not come out. Dentists use the same method with tooth cavities.