Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Splitting a spindle

Posts

Splitting a spindle

#1

Splitting a spindle

Paul Porter in Phoenix, AZ

Hi All,

I have a customer who wants a spindle split in half after being turned. The finished size of the spindle we be 2-3/8" sq. by 48" long. I have seen turner glue a sheet of paper between the two halfs and split it that way. Would that work for a 4 foot long piece? I have never tried this before. I think I'll try a test piece first before I would attempt the longer piece. Any suggestions or stories of experience with this method would be greatly appreciated.

Thanks in advance,

Paul

Re: Splitting a spindle

#3

Brad Vietje

Re: Yes it works, go for it.

Brad Vietje

Paul,

You can also add a band clamp on either end if you want, but it won't be necessary if you get a tight glue join. Be sure the extra "tails" are pointing away from you, so you don't get hurt as they spin. If you do use clamps, you can turn a recess to hold them down out of the way, but that will require extra length.

Safe spinning,

Brad Vietje

Newbury, VT

Re: Splitting a spindle

#4

Re: Yes it works, go for it.

John Lucas

I just use newspaper it works fine. What you have to be careful with is the drive center and tail center. They act like a wedge and split the glue joint. I orient the drive center at 45 degrees to the glue joint to avoid problems on that end. I use a cup center on the tailstock end. I've never had one come apart but if you get nervous simply turn one or two sections and put a hose clamp on or wrap strapping taper around it.

If you need to get the glue off the back use white vinegar. It softens the glue so it can be easily scraped off.

Re: Splitting a spindle

#5

Re: Yes it works, go for it.

Keith Newton----Little Rock, Arkansas

Seems like adding an inch to each end for a few screws would be a good easy way to insure that the ends stay together. Then I wouldn't worry about it if the glue is fully dry. Cut that part off after turning.

Re: Splitting a spindle

#6

Re: Yes it works, go for it.

Joe Herrmann

That's what I usually do and then cut off the extra length when the turning is done. I figure it's cheap insurance.

Re: Splitting a spindle

#7

Re: Splitting a spindle

Sean Troy

Works well with brown paper. I also on the longer spindles used two sided velcro as a wrap to feel safer as I finished one part and moved to the next. Sometimes using several wraps.

Re: Splitting a spindle

#8

Re: Splitting a spindle

Paul Porter in Phoenix, AZ

Thanks guys...I think I'll do a test piece before I turn the real thing.