Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Lathe Setup

Posts

Lathe Setup

#1

Lathe Setup

Bob in NE Ohio

I have been working flat stock for about 30 years as a hobby and for that entire time a late has been standing upright in the corner of my shop. Today I have decided to take the leap and set it up. It has a 16" swing and 36" between centers. If I wanted to make a stand, how should I judge the correct height?

Thanks in advance for the help.

Bob

Moving into the round world!

Re: Lathe Setup

#2

Re: Lathe Setup

Mike Brazeau

Bob - the common rule of elbow is that the centerline should be at elbow height. Have fun and be prepared to open your wallet. You have a lot of catchen up to do! Welcome to the round world.

Re: Lathe Setup

#3

Re: Lathe Setup

Keith Newton----Little Rock, Arkansas

Congrats Bob. I agree with Mike, but suggest that you might reveal how you plan to build that stand, then seek advice about that technique. It may not matter if you only intend to do spindles, but with that much swing, you probably will be tempted to mount a big chunk of found wood on there. Twould be a shame to find that you need to junk the first attempt.

I'm not sure it is possible to over-engineer or over-build. Just saying.

Re: Lathe Setup

#4

Joe Fleming

Re: Lathe Setup

Joe Fleming

Bob,

An orthopedic surgeon and turner friend of mine told me that if you plan to do more face work than spindles, consider setting the center to about 4 inches above your elbow. Otherwise, you will be bending over a lot. If you are primarily doing spindles, then the elbow height rule is good.

Joe Fleming - San Diego

Re: Lathe Setup

#5

Re: Lathe Setup

Jeff Willaford

Listen to Joe. I set my lathe at elbow/centerline height and raised it after my back told me to do so but I turn bowls and hollow forms for the most part. Whatever stand you make consider how you mount the lathe. You want to be able to clean shavings from underneath the bed. You might want to be able to raise or lower the lathe without having to make major mods to the stand. Stability aka vibration dampening is a consideration. I added 600 lbs of sand to my stand for this purpose. Somewhere along the way you might even want to move the lathe for better access so consider that. Just thinking out loud.

Re: Lathe Setup

#6

A lathe base can never be.......

JamieDonaldson

...too sturdy or too heavy!

Re: Lathe Setup

#7

Re: Lathe Setup

Bob in NE Ohio

Thanks To All

The information is a great help

Bob

Re: Lathe Setup

#8

Dick Hines

Re: Lathe Setup

Dick Hines

As far as I am conserned there is no right height. It all depends on what you turn. Bowls and hollow forms will have the height higher than spindles.

I have my lathe at 50" at the center of the spindle. I keep a milk crate handy so visitors can use the lathe if they want.

First and formost is make it counfortable for you.

Re: Lathe Setup

#9

JL

Adjustable, of course.

JL

:D . Seriously - if you have to make a cabinet or stand, put adjustable feet on the base. That way, you can fine tune it. I have the center of my spindle at ~49" and I have a floor mat that is ~1" thick.