Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Need oil seals for Delta lathe

Posts

Need oil seals for Delta lathe

#1

Need oil seals for Delta lathe

David Miller from Iowa

I just got a lathe like this (this is not mine, but mine is the same). The previous owner pulled out the oil seals and packed the bearings with grease. I want to put it back - everything is still fine, just the seals are gone. Anyone have a source for replacements? What is the correct lube for this? Thanks

Re: Need oil seals for Delta lathe

#2

Re: Need oil seals for Delta lathe

Mike Brazeau

I have one of these beauties with the original stand which was cast iron legs and heavy 2x10 planks of pine with 1/3 HP motor. Haven't used for some time but refuse to part with it. At Vintage Machinery site http://vintagemachinery.org/pubs/detail.aspx?id=500 the manual recommends light machine oil for the bearings. Paid $150 Cdn in 1970 with Delta Carbon Steel tool set which I also still have.

Re: Need oil seals for Delta lathe

#3

I'm quite surprised that the bearing.....

JamieDonaldson

..lube suggested was light oil rather than bearing weight grease?

Re: Need oil seals for Delta lathe

#4

Re: I'm quite surprised that the bearing.....

Bruce Smith

Not sure what type oil is required but like someone else suggested light machine oil would probably fill the requirements. As far as oil seals they should not be to difficult to obtain. Try you local seal and or bearing business, they sometimes are a division of a power transmission shop. Measure the outside diameter of the headstock seal bore and also the outside diameter of the shaft the seal runs on and purchase a seal that fits these dimensions. If you don't have a vernier caliper or similar measuring device, dismantle the head stock and take both the housing and the shaft to the shop and have them measure it you should ask for a double lip seal. They no doubt will be able to fill your requirements. Good Luck