Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Paper joint candle holders

Posts

Paper joint candle holders

#1

Paper joint candle holders

John Lucas

Sometime in the late 80's I learned about using paper joints in woodturning. I found this image while cleaning the house. Obviously I did these shortly after doing the other wall mounted candle holders I posted. This is still a good project for beginners.

for the back plate glue 2 pieces of walnut together with a scrap of wood inbetween. put newspaper or brown paper between the wood while you glue it up. Add more scrap wood to the outside. Then just turn it between centers. Turn the ends down as small as you dare. You'll have to carve away the very top and bottom after removing them from the lathe. Stick a chisel or knife in the paper joint and drive it down through. The should pop apart. Soak the glue and paper with White vinegar and you should be able to scrape it off.

For the candleholder glue 2 thicker boards together with the paper joint. Turn this between centers and carve away the waste just like you did above. Remove the glue. Drill a hole in the top for the candle glass.

Now just glue them onto the backing plate. For these I caved out a dished area and colored it gold with paint.

Re: Paper joint candle holders

#2

Re: Paper joint candle holders

GaryG in MD

John, How hard is it to get rid of the glue/paper, and what does the vinegar soak do to the wood? Do you have to remove much wood from where the glue was to get it into finishing condition? ...Gary

Re: Paper joint candle holders

#3

Re: Paper joint candle holders

john lucas

Gary So far on the woods I've worked with the White Vinegar doesn't do anything other than raise the grain. It might take several applications to get it all off. I originally tried sanding the paper glue joint off. It clogs the sandpaper immediately. Of course that was good because I learned to use a file card to clean the belt so that was a good lesson.

Then I tried a hand scraper. It chips out the edges of some of the details if you aren't really really careful.

I ended up using the white vinegar and a sharpened 1" drywall knife to speed up the process. It makes a really gooey mess but wipes off well if you let the vinegar soak in with several applications.

Re: Paper joint candle holders

#4

Re: Paper joint candle holders

R Henrickson

If the glue is Titebond or similar type, you can soften the glue with isopropyl (rubbing) alcohol -- preferably at least 90%. Soak the glue, or moisten a paper towel, and leave covered for at least several minutes. If you use 90% or better, there is little grain raised. This technique is common in the ship modeling area.