Well my last tea pot has just arrived at its new home
I didn�t realize how attached Id become to this piece and how satisfying it was when other woodies visited to pull out Tea leaves and show them what I considered to be last years flag ship piece I had made.
Not to cry over spilt milk I have started another
No1 I liked No 2 I loved I just hope this one measures up to its brothers
Here it is seen ready to remove from the lathe and go to my carving, Pyrography sanding, airbrushing area.
It will be returned to the lathe at a later date to reshape the base and form the ring from which I will carve 3 feet .Always a risky part of the manufacture as I have ruined a few at this stage
The timber is some sort of Eucalypt and has been quite sickly to turn ,as it smells like an old sock that has had liniment added
I estimate about 16 hours more work to completion
And I may revisit the lid after carving as I don�t think the shape quite suits tea teapot
I'm sure that this one will be as good or better than the first. Is that a hole in the piece close to the jaws? Looking forward to seeing this completed.
Very cool, Terry. I'm interested to know more about your process.
What's the tape for?
How does that dust collection pipe work for you?
What kind of lathe is that?
What was the order of work to get to where you are now? It looks like you probably turned the bottom side first, including the spigot, then reverse-chucked it to turn the top. At this point in the series of photos, you've already sawn away the opposing wings and smoothed the remaining ones. What tools did you use to do that?
How will you reverse chuck the pot to turn the feet? Jam chuck?
Do you make the spout and handle separately and attach them somehow to the wings?
Thanks for the inspiring photos. You don't cease to amaze.
Terry's winged pieces have always amazed me. Thanks Ellis for asking all the right questions. Come-On Terry, spill the process, preferably with photos. Thanks!!!
Very cool, Terry. I'm interested to know more about your process.
Quite a development process and many hours of failures to figure out how I was to do these . They evolved from my winged boxes
What's the tape for?To protect the areas against woopsies .The tape gives some protection to areas that will be hard to sand
How does that dust collection pipe work for you? Allot better I have just added a reticulated arm so that at a simple touch I can move the dust nozzle and it is all spring loaded and stays were I shift it . I found I were not using the extractor because it was a military operation to move.
Sticking the 100mm pipe has doubled the intake of dust as the shoot was not working
What kind of lathe is that? Omega Stubby 1000 only one of 3 in nz
What was the order of work to get to where you are now? It looks like you probably turned the bottom side first, including the spigot, then reverse-chucked it to turn the top.This piece has been re chucked 6 times
First as you say
At this point in the series of photos, you've already sawn away the opposing Your not supposed to tell anyone L.o.l wings and smoothed the remaining ones. What tools did you use to do that? A host of my stable The merlin comes in handy
How will you reverse chuck the pot to turn the feet? Jam chuck?
I will use A jam chuck ,hot melt glue ,friction chuck masking tape bring the tail stock up chuck .What ever it takes I pride myself on saying there isn't an item I cannot hold on the lathe.I enjoy this challenge
Do you make the spout and handle separately and attach them somehow to the wings? All in one piece If you turn a bowl shape then with hot melt glue you can pivot the work to turn I call this the rocker as it enables me to turn mulity axis any were on a sphere
Thanks for the inspiring photos. You don't cease to amaze.Thanks but it just proves I can fool most of the people all of the time L.o.l