Spinning Winged Cup Progress
charlie belden
Posted an unplanned piece earlier of a winged cup that balanced on the pull of a lidded box lid The cup could be spun - and not fall off the "pull". That prompted the idea for Version 2.0 of the balancing, spinning idea.
Here's the idea - and where I'm at with it at the moment.



The "wing's will get "carved" (sanding disked), the finail will get inlayed into this thing's lid. The idea of a Spinning Transformer Winged Lidded Box - With Finial has been fun so far. The cool part is that anyone could make their own version. The wings are rough - but the carving and disk sanding will take care of that.
'm hoping this thing will spin by blowing on it. Will keep you posted.
If I make something spin, it will probably be a snack tray
I've been playing with winged forms lately, but also turning them off center on the long axis as well. Alas, Winter has finally bared its teeth a little these past few days. I finally found temperature & moisture limitations for Gorilla glue. Couldn't re-attach a wing I knocked off. I might have to wait for the end of the week before I venture back out to the shop. Just drove through about 5" of snow on the way home from work, and its still falling.


