Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

Rikon 70-500

Posts

Rikon 70-500

#1

Rikon 70-500

Ken DeMarco

I am seriously considering buying a new Rikon 70-500 (woodfast) lathe, and was wondering if anyone here has used one? one of my concerns right now is the outboard side has LH threads, other than Oneway are there any other faceplates that come with RH/LH threads, and any concerns I should have with using cross-threaded adapters?

Thanks

Ken DeMarco

Re: Rikon 70-500

#2

I have some double thread faceplates....

JamieDonaldson

...for my old General. Never had any problems with cross threading, but I seldom use them now.

Re: Rikon 70-500

#3

Re: Rikon 70-500

John Lucas

Delta used make cross threaded faceplates. They were 1"x8 rh and Lh. I don't know where you would get them. Anyone with a metal lathe and some threading skill can put cross threads in your existing faceplate or make a new one.

Re: Rikon 70-500

#4

Re: Rikon 70-500

Mike Foster

Ken,

I have a used Woodfast longbed with riser blocks and variable speed. Email me if you are interested.

Mike

Re: Rikon 70-500

#5

Re: Rikon 70-500

Doug Turner

Ken, I have a short bed 16" VS Woodfast cica 1982. They are built much better than the Rikon. I believe the original ones were mfgd in Australia not China. A friend bought the tabletop Rikon and broke several parts while he was trying to learn. The casting seemed very brittle and in one case just crumbled. I tried to get him to return it to WoodCraft where he bought it, but he ended up throwing it out in the trash. I am sure WoodCraft would have stood behind it, but he was fed up with it.

My Woodfast will surely outlast me and perhaps a couple of other woodturners with reasonable care and maintenance. This is one of those tools I would buy again Charlie was talking about.

Doug

Re: Rikon 70-500

#6

Re: Rikon 70-500

Ken Demarco

Well, thanks for the input. Not sure what I'm going to do Woodcraft is having a one day 15% off sale on Rikon tools this Saturday, which made this seem pretty interesting. I had been looking at the PM 3520 untill they priced it well out of my range last week. I also looked at the Laguna/Grizzly 18" lathes but way too many bad reviews on those. So I will either buy one this Sat... or not.

Ken

Re: Rikon 70-500

#7

JL

There's always a Jet 1642   

JL