honey locust in the Buckeye State
Ace Foster
A friend of mine in Reynoldsburg, Ohio (just east of Columbus) just had a honey locust taken down. Apparently big enough to have some turning stock in it. Anybody interested?
Knowledge You Can Build On — Est. 1998
honey locust in the Buckeye State
Ace Foster
A friend of mine in Reynoldsburg, Ohio (just east of Columbus) just had a honey locust taken down. Apparently big enough to have some turning stock in it. Anybody interested?
Re: honey locust in the Buckeye State
Rob Wallace
Get as much as you can and turn it green ASAP - it becomes very hard and much more of a challenge to turn when dry...it's beautiful wood...
Wish I was closer to the Buckeye State..... Although Iowa is often confused with Ohio... 
Rob Wallace
Re: honey locust in the Buckeye State
Jorge Casta�eda
I wish I was closer, I love that wood
If you get big pieces, 16" or so and are willing to part with some, we can arrange something.
Jorge
Re: honey locust in the Buckeye State
Steve Kubien
Rob, is your advice to turn it to finish while green? If so, how thin do I need to go? Is it prone to cracking like, say, cherry and oak or is it more forgiving? If I am to twice-turn it, do I follow the 10% rule? I just into a wee bit of honey locust (cut up some yesterday and will finish the second log next week).
Thanks,
Steve
Re: honey locust in the Buckeye State
Rob Wallace
Hi Steve!
Funny you should reply - it feels like Canada here!! (...-11^C with a -22^C wind chill!!). 
In my experience, honey locust can be twice-turned, and is only moderately prone to checking - I think it's a bit more forgiving than oak. I would not necessarily finish it green, but I think it could stand to be a bit thinner than the standard 10% rule - it's perhaps a bit more stable upon drying than most of the domestic hardwoods I've worked from the central USA. (the pieces I've done with it have not warped out of round very much.) Sharp tools will clean it up nicely on the second turning, but I wouldn't want to necessarily hollow a large bowl of honey locust when it's fully dry. It gets quite hard, and as you know it's fairly dense. I would turn it green, not too thin, and then allow it to dry slowly until you reach equilibrium and the weight is stable (I often coat the entire outside of my roughed pieces with Anchorseal, and then air-dry slowly in my basement storage area adjacent to the shop)
If memory serves, honey locust was often used as the log in contact with the ground when early settlers were building log cabins - had a fair amount of "longevity" relative to other wood species. I do like the visual effect the wood of this species (Gleditsia triacanthos) has with its pretty color, and strong figure. It sands and finishes well too.
I hope this helps!
Rob
Re: honey locust in the Buckeye State
Jorge Casta�eda
Steve,
I've done around a dozen honey locust pieces and the only one that developed cracks was a crotch piece. The wood is quite stable and for a 16" bowl, I rough it to 7/8", wait until very dry and work with very sharp tools and small bites, it is very stringy but finishes quite well, beautiful color and grain.
Thanks guys
Steve Kubien