Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

please help ID this lathe part

Posts

please help ID this lathe part

#1

please help ID this lathe part

David Miller from Iowa

I bought a storage unit full of vintage Delta tools, including a 12" lathe. This was in with the tool rests, banjos and faceplates, but it is not a Delta part. It has a 1" post and fits fine in the banjo, but I am not familiar with it. Says York on it. Anyone?


Re: please help ID this lathe part

#2

Re: please help ID this lathe part

bill Hayes

Looks like a yoke for metal spinning tools

Re: please help ID this lathe part

#3

It looks like a yoke for ...

Ed Moore in SW VA

holding one end of a weightlifting bar.

Ed

Re: please help ID this lathe part

#4

Mike Stafford

Re: It looks like a yoke for ...

Mike Stafford

I have no idea what it is but York Barbell Company did make weightlifting equipment.

This York could be entirely different....

Re: please help ID this lathe part

#5

It's..."Your York Yoke" now!!! 

mjonesrdg

>

Re: please help ID this lathe part

#6

Re: It looks like a yoke for ...

john lopez

From my corner of the peanut gallery it looks like a specialized toolrest .

More specifically a semi-gated toolrest or yoke

one might use when working in close on the foot of a bowl or on a coring

operation.

The current AAW magazine has photos of a few shop made toolrests

in the "Hints" section.

One of them is a simliar ground out small yoke type for parting off.

Somewhere on the internet you might find vintage Delta catalogs and

owners manuals if you try searching for them.

If it was mine I'd clean it up and try it as such.

Re: please help ID this lathe part

#7

Re: It's..."Your York Yoke" now!!!

Bob Macgregor

Unless you find out its not really a yoke...then the yokes on you!