Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

REAL MILK PAINT

waterlox curing question

Posts

waterlox curing question

#1

waterlox curing question

Mark Wollschlager

I am in the process of making a last minute secret santa ( for work ) present.

It is a myrtle bowl with waterlox original as the finish.

I usually do 4 or 5 thin wipe on coats, sanding with very fine grit between coats.

I generally allow at least 24 hours between coats at room temp.

I also allow for a generous post finish application 'degassing' period.

In this case it will be 3 wipe on coats with the piece at an elevated temp.

Between 80-90 degrees ( ambient temp in my shop is 55 today ).

I have been applying the finish and leaving it unheated for an hour or so before elevating the temp.

The question is, could I crank the temp up a bit higher ( 100-110 ) without damaging the finish.

It is a somewhat desperate attempt to drive off the solvent odor for a Monday delivery.

Thanks,

mark

Re: waterlox curing question

#2

Re: waterlox curing question

Carole Valentine

Never really tried to rush Waterlox that much. Not sure how the higher temp would affect it...hope it would not harden the outside first, sealing uncured finish beneath. Maybe if it would work if you wipe each coat almost dry before allowing it to cure at the higher temperature. Just my thoughts.

Re: waterlox curing question

#3

Re: waterlox curing question

Doc Green

Mark, keep in mind that the elevated temp may have some effect on the bowl itself, causing it to warp or, at worst, crack. A temp of 110 is quite warm for a wooden bowl if it is not bone dry.

Re: waterlox curing question

#4

Re: waterlox curing question

Mark Wollschlager

Thanks all.

I think I will keep the temp down for now.

It has to come up to room temp sometime.

I just hate the smell so I don't bring the pieces in the house this time of the year while finishing.

Re: waterlox curing question

#5

Re: waterlox curing question

Barbara Gill

Mark that seems like a good question to ask the manufacturer of Waterlox.