Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

These will be altar candlesticks

Posts

These will be altar candlesticks

#1

JL

These will be altar candlesticks

JL

They'll be using oil filled tapers that are 1 1/4" in diameter at the base (and quite tall).


I took some elements of the Eli Avisera candlestick on the link supplied by Heather. I blended it with some of my Windsor chair baluster leg design.

All in all, they aren't too bad. The next question is, how do I do the long torches that the torch bearers carry. I suppose I could make them segmented and use the hardware for canes.

Re: These will be altar candlesticks

#2

Keith Tompkins

Re: These will be altar candlesticks

Keith Tompkins

Hi JL, Not too bad at all! They'll be very pleased with these.

Re: These will be altar candlesticks

#3

Leo Cuellar

Re: These will be altar candlesticks

Leo Cuellar

They "turned" out very nice indeed!

Re: These will be altar candlesticks

#4

Mike Stafford

Re: These will be altar candlesticks

Mike Stafford

Jerome, the candlesticks are quite lovely. Your work as always is impeccable.

Could you make the long torches with sockets and tenons and glue them together?

Re: These will be altar candlesticks

#5

JL

Not sure.

JL

I don't like the thought of that narrow a tenon. Figure that the torches have to be ~5' tall and comfortable enough to hold in a child's hand. To me that means about 1 1/4 - 1 1/2" in diameter. It also has to have a cup to hold the torch (candlestick) and a splash (or whatever you call the round thing around a cup - saucer maybe?). This would mean a tenon that's 1/2" to 3/4" and a corresponding socket.

That's a bit on the thin side for my taste. I may do a test out of some soft maple that I have to see how it holds up. My other thought was to get the cane hardware and use that. They have the screw threads that will hold two pieces together.

Re: These will be altar candlesticks

#6

Mike Stafford

Use a steel tenon.....

Mike Stafford

I have frequently reinforced joints with steel or brass rods.