Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

Var Speed on a Delta Midi Lathe?

Posts

Var Speed on a Delta Midi Lathe?

#1

Var Speed on a Delta Midi Lathe?

Andy Lincoln,in Dearborn MI

Hi All,

I have a Delta Midi lathe LA200.Is there any reason that I could not use a dimmer switch or a router speed control switch to make my lathe variable speed?

I have seen a finishing technique that involves a few speed changes that I would believe to be cumbersome and time consuming just to finish a pen, by changing the belt/pulley arrangement.

i also have seen that PSI sells a replacement motor/switch kit that will turn a lathe into VS.It is $100 plus shipping and I was looking for an alternative.

Remember I am not an electrical wizard ,but can follow instructions.

Thanks,

Andy

Re: Var Speed on a Delta Midi Lathe?

#2

Re: Var Speed on a Delta Midi Lathe?

Bill Howatt

The motor on the lathe is an induction motor and this means it cannot be made variable speed with a dimmer switch or router speed control.

Universal motors such as used on electric drills can be controlled that way but it cause the induction motor to have very, very little power and overheat.

Bill

Re: Var Speed on a Delta Midi Lathe?

#3

Re: Var Speed on a Delta Midi Lathe?

john lucas

I looked at the Penn State Ind. motor and controller and got 2 lprivate e-mails from individuals who purchased it and were not happy. Apparently it is far underpowered.

I looked into buying DC motor and controllers directly from Jet. You can buy the lathe for just a few dollars more. Not worth it.

I'm going to convert my old Nova Comet to variable speed but I'm going to go the Variable Frequency Drive and 3 phase motor route. Same for my metal lathe. You maintain more power at the low rpm end and you can add reverse and even electronic braking.

Re: Var Speed on a Delta Midi Lathe?

#4

Re: Var Speed on a Delta Midi Lathe?

Peter Lamb

Sell the 200 and purchase a Delta 46-460 about $599. I have one and love it.

Re: Var Speed on a Delta Midi Lathe?

#5

Re: Var Speed on a Delta Midi Lathe?

Bill Turpin in WNC mountains

I converted a Fische mini lathe with the PSI kit. It is 1/2 HP just like the original. I turned an 8" bowl in red maple with a 1/2" bowl gouge. Had no problem with under power. This was three years ago and the kit may have changed.

Re: Var Speed on a Delta Midi Lathe?

#6

Ken Vaughan

Re: Var Speed on a Delta Midi Lathe?

Ken Vaughan

I have one of the PSI DC motors and find it quite satisfactory if you know it really wants to turn at about 1/2 speed or faster --

That style of motor needs to have the motor running pretty fast or the torque drops off fast at low motor speeds. -- It comes with a sheeve for the midi lathe and you need to change belts to keep torque at lower spingle RPMs.

Variable Frequency Drive is the much higher priced alternative with much better low speed performance, but even with VFD, there is a definite drop off of Torque.