Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Need suggestions & tips on Kallenshaan pen kits

Posts

Need suggestions & tips on Kallenshaan pen kits

#1

George Taylor

Need suggestions & tips on Kallenshaan pen kits

George Taylor

I do not do a lot of pens but I had some requests to make several of these; web site and paper directions do not give much instruction (especially on the assembly); is there a video or other instructions that highlight things that would be helpful? The kits are not cheap so I would rather not make a big mistake if I do not have to. I am mostly concerned on the assembly, not the turning.

Thanks

George

Re: Need suggestions & tips on Kallenshaan pen kits

#2

Re: Need suggestions & tips on Kallenshaan pen kit *LINK*

Ed Davidson

George,

I made a three-part how-to on the Stars & Stripes kits several years ago, but think the content may still be useful. You'll find the link to my online tutorial page below - look for Video Tutorial # 20.


http://yoyospin.com/tutorials/

Re: Need suggestions & tips on Kallenshaan pen kits

#3

Re: Need suggestions & tips on Kallenshaan pen kit

Donna P

Hi George,

Which kits are you considering?

-Donna P.

Re: Need suggestions & tips on Kallenshaan pen kits

#4

George Taylor

Re: Need suggestions & tips on Kallenshaan pen kit

George Taylor

I have 3; golfer, balloons and several woodturner kits. All will be gifts and are made for the Sierra kit.

Thanks

George

Re: Need suggestions & tips on Kallenshaan pen kits

#5

George Taylor

Thanks Ed, just what I was looking for.

George Taylor

Re: Need suggestions & tips on Kallenshaan pen kits

#6

Re: Need suggestions & tips on Kallenshaan pen kit

Donna P

Hi George,

I have to say that's Ed's link is what helped me get going. I re-read the instructions that came with my pen kits and am unable to think of anything else to add. On the kits that suggest epoxy to glue the tube in, make sure it's think epoxy or it will run to the bottom of the tube. Also, if I can't press in a piece with my fingers, I use long nose pliers that I've bent the ends in towards each other to help press in some pieces.

Donna P.