Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Live Edge Slabs, Hand-Selected in the Berkshires. Shop Unique Hardwood Pieces.

LinkBelt and Lathe?

Posts

LinkBelt and Lathe?

#1

LinkBelt and Lathe?

Thomas Norton

On an earlier post I ask about the correct height to remount my lathe. Thanks to all who responded!

When I do re-position my lathe I was wondering if a LinkBelt would work?

Re: LinkBelt and Lathe?

#2

Re: LinkBelt and Lathe?

John Lucas

I've had good success with them on two different lathes. One even had a reeves drive which they aren't supposed to be good on. Be aware there are two sizes. I forget what they are now but you do need to buy the correct size or they won't fit down in the pulley correctly

Re: LinkBelt and Lathe?

#3

Re: LinkBelt and Lathe?

robo hippy

My first lathe was a 4 speed/pulley Atlas. I built a bigger heavier stand for it, and used a link belt. Perfect for the job. I did not have to take the headstock apart to replace the belt, I could leave a little slack in it which made it really easy to change speeds, and it lost no torque. Also, after the belt stretched out a bit, it was simple to remove a link or two (easiest to do with needle nose pliers) to tension the belt back up proper.

robo hippy

Re: LinkBelt and Lathe?

#4

LinkBelt and Lathe? Why sure...

Scott Burr in Ben Lomond CA

Just make sure you have the belts going in the right direction and remember they will stretch a bit after a few uses. Also if your lathe runs in reverse the belt can do it but it's a bit noisy and not as smooth running.

Re: LinkBelt and Lathe?

#5

Re: LinkBelt and Lathe?

Janet Bequeaith

Yes, there are two sizes, 3/8 and 1/2. I have a General table saw and it takes the 3/8 one. I'll have to check my lathe size.

Re: LinkBelt and Lathe?

#6

5/8 Too

Bill Howatt