Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Channelling my inner John Lucas

Posts

Channelling my inner John Lucas

#1

Steven Antonucci

Channelling my inner John Lucas

steven antonucci

I've been up since 6AM and in the shop since 7AM. Couldn't sleep, and also couldn't use the big equipment out of respect for my neighbor's Sunday mornings. I turned on Metallica, and began putzing around doing things that weren't louder than my 4 walls could contain.

I had a little stub of a turning left in the chuck and I started playing, trying to turn it thinner and thinner. I noticed it seemed to take a lot of abuse, and it cut down to almost nothing, so I decided to channel John Lucas and try a mini goblet. (Sorry John, if you felt me bumpin' around inside your head this morning! :) )

This goblet was drilled out with the smallest drillbit I could find, which was probably 1/32" (too small to read the lettering). I turned it with a full sized 5/16" Thomspon detail gouge. It is .145" long, .085' wide, with a .027" stem.


Pithy comments welcome :b

Steve

Re: Channelling my inner John Lucas

#2

JL

I hope it isn't "catching"...

JL

you can take that either way.

Re: Channelling my inner John Lucas

#3

Rob Wallace

Parting off....

Rob Wallace

.... can be a challenge!

When I do demos of making micro-tops (...I've never done a goblet), I keep a piece of black felt in my tool kit that I put on the bed of the lathe and then slowly part-off the top so the piece lands on the black felt and can be easily found. Alternatively, I sometimes have an audience member catch the piece as it falls from the lathe. I usually turn the tops out of osage orange, and then test them by spinning them on a plastic tray with a lip. The tops that are smaller than 3/16" are much harder to spin with my stubby fingers, but they still work. Even more impressive is when you turn them with a BIG skew (I use my Lacer 1-3/8").

I suppose you've now set the challenge for me to make some micro-ornaments at our woodturners meeting this afternoon...

Question - Was the drill bit used for hollowing this goblet held in a captured-arm/outrigger system, or did you use an articulated arm system?? ;)

Thanks for showing!

Rob

Re: Channelling my inner John Lucas

#4

Jim in Burlington Ont.

Re: Channelling my inner John Lucas

Jim in River Oaks, Ont.

You always amaze me my friend, you take on a challenge and go for it full out!

:-)

Take care,

Jim

Re: Channelling my inner John Lucas

#5

Re: Channelling my inner John Lucas

john lucas

Great Steve. I was out of town this weekend and thought I felt strange. I had this urge to turn something small.