I toasted the velcro on my sanding disc holder/mandrel. While I'm waiting for a replacement, I'm thinking I'll glue an interface pad to it. Heat from friction rules out epoxy, I think. CA might melt the foam. Would PVA do the trick? Or maybe spray adhesive? Any suggestions?
Designed to convert a 5" PSA ROS into Hook and loop. It had PSA on it and all you were supposed to do was stick directly on you PSA sander. My sander had a worn out H&L pad, so I sanded it smooth and applied the new disk. I have not tried it yet.
The disk was about $4.95. You could make three or four two inch disks out of it. I did not see a 6" version, but I was not looking.
I use contact cement. I use the same stuff I install formica with however you the contact cement you get at the hardware store in the little brown bottle is the same stuff.