OK, all you heavy thinkers out there. How come when a tool rolls off the lathe bed it will ways land on the tip. Even with my Kelton handles that out weight the tool end 2 to 1 it will alwasy land on the tip.
This should keep you heavy thinkers busy for a while.
First of all I am guessing. This is a SWAG and has no scientific basis in fact.
My guess is that because the tool is laying on the lathe bed with the cutting edge hanging off because the handle is heavier. When the tool begins to roll the tool becomes unbalanced and since the tool shaft is already off the bed it is the first part to succumb to gravity heads to the floor first.
Put rubber mats on the floor and turn with steel toed boots.....
You've only touched on one of sharp tools' behavior s- always seeming to land on their cutting edge. But you stopped too soon.
Once on the floor they will, almost always, roll under the heaviest thing in the shop and invariably stop in the most inaccessible place. AND, that location will often be next to - something that bites, stings, stinks - or all three - and which has a nasty attitude towards human extremities - like a hand or finger. There is a suppressed mischievousness in kids and sharp tools - that sometimes seems to be pure evil. With kids that isn't actually the case. With sharp tools - well the jury is still out : )
When not using your tools, strap each one to the back of a sleeping cat. That way, if it falls off, the cat will land on its feet and the tool will be unharmed.
Just remember to remove the cat before using the tool - not only will the cat mess up the balance, the coughing and spitting when the cat wakes up, covered in shavings, is distracting.
. . .to say nothing of the distracting nature of the wounds the cat will inflict upon you.
True Story
Two men, Man A and Man B, brothers in law, are sitting in Man A's kitchen after a night of some pretty heavy drinking. Man B, seeing Man A's cat walk by, has, what could only be thought to be a good idea by a drunk, proposes scaring the hell out of the poor feline.
"Let's throw the cat over the garage!" says Man B.
Man A, being somewhat intelligent even when drunk, thinks that would be a really stupid thing to do - because it would a) injure the cat and b) he'd have to pay the vet bill to repair the cat.
Man A then suggests that someone be on the other side of the garage - to catch the cat so it wouldn't be injured - and thus also avoid vet bills.
The two drunks discuss how all this might be done and come up with a plan.
Man A, who owns the cat, will be the Cat Hurler and Man B, who is noted for having "Good Hands" will be the Cat Catcher. Man B,the Cat Catcher, will count out loud to three 1-2-3. Man A, the Cat Hurler, will use Man B's voice to locate him and know where to hurl the cat.
The evaluation of this brilliant plan stops at that point and the execution of the plan is begun almost immediately (slow, sleepy cat).
Had either of the gentleman taken a bit more time evaluating the plan, or been a bit less inebriated, the obvious end result would probably been obvious.
To his credit, Man B realized, after the cat was in the air - screaming bloody murder - that the flying cat's mental state would be one of absolute terror resulting in a real desire to grab on to any stabile object it encountered - with all available claws - and teeth - and despite that knowledge, caught the feline.
Man B's new $400 leather jacket took the brunt of the claws, but he did sustain several deep claw and teeth marks in his forearms and hands. The cat sustained no physical injuries - but later defecated and urinated in Man A's Porsche.
Neither man spoke to the other for nearly five years, especially when inebriated.