Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Saw runout OT

Posts

Saw runout OT

#1

Saw runout OT

bill Crommett

I have a radial arm saw that I use for a dedicated cross-cut that has to be re-calibrated every few years. After getting the blade sharpened I found that the closest I could get to 90 degrees had a run-out of .007 in 6 inches. Can any of you mathematicians/engineers tell me how many degrees/minutes this converts to ?

Re: Saw runout OT

#2

Re: Saw runout OT

john lucas

No but I have the same problem only worse with the Craftsman that I picked up this spring. When locked you can still move the arm slightly. I hope to have time to trouble shoot the problem shortly. I want to sell it because I don't need it. I understand this is a common problem with this saw so finding the solution and solving it will be interesting.

Re: Saw runout OT

#3

Re: Saw runout OT

Bill Howatt

The angle would be arctan 0.007/6 = arctan 7/6000.

The angle is 0.0668 degrees.

Bill

Re: Saw runout OT

#4

Keith Tompkins

Re: Saw runout OT

Keith Tompkins

HI Bill, Do you have the operator's manual? There should be some provision for fine-turning. On my DeWalt,there are several, including set-screws in the base of the column. It may be necessary to adjust the column at the base, then readjust the arm to 90 degrees in the usual method.

Re: Saw runout OT

#5

Re: Saw runout OT

bill Crommett

Thank you all for your replies. This saw is a Craftsman w/12 in. blade and is probably 35 years old, built when Craftsman was a sign of quality. It has been sitting for so long as a dedicated cut-off that the column seems to be stuck in a 90 +/- degree position and I am afraid to force it to move for fear that I will never get it that close again. I can live with a run-out of 0.069 degrees which will cause an error of less than 1/2 of an inch in ten feet. You young Bucks won't understand, but with age we have a tendency to leave the problems to the next guy.