Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

Hollow forms

Posts

Hollow forms

#1

Hollow forms

Jeff Rich

I have just started doing a few hollow forms at the request of Cheri.

This is to help her with the birdhouses and make some urns....

I have made Ellsworth type tools and they work out great, when you get the handle drilled properly.....and the tool shaft.

I now have to modify my lathe a bit, the tool rest is too high when using the extension arm. This does not allow me to get the nib out at the bottom and I have tried angling the tool all every which way. Yes it is a Harbor Freight lathe with a swivel head, but it works well for little forms.

The bent tool will catch on the bottom and smash your finger, my index finger is a bit this morning.

It is a learning experience but if you let go and feel, you can feel the ridges and work them away, it is very exciting.

Re: Hollow forms

#2

Re: Hollow forms

GaryG in MD

Jeff, It's not clear from your post exactly what you're doing, but it sounds like you're trying to use the bent tool on the centerline. You don't want to do that. Use a straight tool to go to the bottom and to work to the sides as far as the opening will permit. Use the bent tool only when you have to on the sides. The bent tool should never touch the bottom -- only the sides. ...Gary

Re: Hollow forms

#3

Re: Hollow forms

Jeff Rich

I am using the straight tool on the center nib as I have found out by a smashed finger about bumping the center with the bent tool. I think I am just having a bit of trouble getting the cut started to take out the nib.