Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Compare cordless drills on the numbers that matter

3520B headstock that is stuck: what to do?

Posts

3520B headstock that is stuck: what to do?

#1

Aage Rendalen

3520B headstock that is stuck: what to do?

Aage Rendalen

How do you untstick a stuck headstock on a mustard machine? The lever releases normally but I can budge the headstock an inch.

Re: 3520B headstock that is stuck: what to do?

#2

I've seen this happen due to a bit.....

JamieDonaldson

...of rust between the bed/headstock surfaces, almost like they were glued together. Get a bigger mallet and give the headstock a good lick!

Re: 3520B headstock that is stuck: what to do?

#3

spray a little WD40 on the seam first.

George Guadiane

Re: 3520B headstock that is stuck: what to do?

#4

Apply more Mustard

Joel

Re: 3520B headstock that is stuck: what to do?

#5

Ric Taylor

Ruth Niles Can Fix it with her Pipe Wrench... 

Ric Taylor

Re: 3520B headstock that is stuck: what to do?

#6

Re: Ruth Niles Can Fix it...no pipe wrench!

Ruth Niles

When this happened to me, I tried every suggestion....except the mustard. : )

The pipe-wrench reference is to the procedure of attaching a length of pipe to the handle of the wrench for mucho leverage. I even jumped on that "leverage" and it didn't work. My faceplate was really, really stuck but I did manage to bend the pipe wrench handle.

I sprayed WD-40, didn't work.

Finally I applied fire, held a small (tiny) torch to the spindle (through the faceplate), then applied ice, then the heat again. It did come loose........however, I also melted the lubricant in the bearings so ended up taking the whole headstock apart to replace both bearings. I now know as much as any tech about The General. : o