Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Just for fun

Posts

Just for fun

#1

Just for fun 

Terry Scott

This was an interesting challenge

Sat in on a Stewart Batty demo In Utah

These are turned from a block of wood that is rather daunting when being turned (Even for me l.o.l) as you have no waste wood and a helicopter whizzing around

This one is about 12 inches long

The first step is to select a straight grained timber free of defects

I used Black Maire

The set out has to be spot on

Then I placed on a screw chuck to turn a spigot on each opposing bowl

Before you can turn the spigot there is allot of waste to turn off to start turning the plank

Sort of turned in quarter sections at a time

Then you turn the inside of the bowls and reverse by holding in the inside of the bowl with the jaws so the foot can be turned off

Making templates of the first bowl so you get them the same is important

You cannot see the edge of the plank so you need to be very confident of your tool skills

so you keep a flat surface

I wont say how fast i turned this as you will have kittens

There is allot of air or gap so the speed has to be wound up the bump bump bump

I made another of these with a sphere on each end with a box lid eon opposing sides

Hunted high and low for a picture but unable to find one

I may have to talk to Gorst to see if he can send me a picture as it resides in his collection


Re: Just for fun

#2

Re: Just for fun

Randy Gleckler

Very nice... and thanks for the explanation on how..

Re: Just for fun

#3

Leo Cuellar

Re: Just for fun

Leo Cuellar

If you only made this 12" long, then it must indeed be a scary proposition! LOL. Not the kind of thing I'll be trying until I get my new lathe this spring.

Re: Just for fun

#4

Love it.   

Garyg in Md

Re: Just for fun

#5

Re: Just for fun

Juergen

Terry

The 1st time I saw a piece like this turned was about 10 years ago by Keith Gotschall of Salida, Colorado. Instead of turning the waste wood off he bandsawed the waste wood and started with a piece of wood that was Z shaped. It certainly cuts down exposure to the propeller.