Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Reach the woodworkers who ACTUALLY BUY

Lost my micro goblet

Posts

Lost my micro goblet

#1

Lost my micro goblet

john lucas

I don't know how because I never opened the lid to the box after I put it in there. I took it to work to show everyone and it was nowhere to be found. Can't imagine how you would lose something that big. I didn't even get to measure it. So I had to bite the bullet and go in the micro shop one more time. I made 3 more this morning. kept blowing up the foot of the goblet so 2 of them got longer stems. It's almost impossible to show in a photo and get the feeling of how small these things really are. This is the last one I did just before cutting it off. Hopefully it will show some scale. I'll try to figure out how to take a photo of it later. Right now I'm going to tape the box shut.

Re: Lost my micro goblet

#2

Steven Antonucci

Put the shavings through a coffee filter

steven antonucci

the only thing left will be your goblet. :)

S

Re: Lost my micro goblet

#3

Re: Lost my micro goblet

Terry Scott

A fly took it home

I loose things ten time that size

John we have a washing machine at home that eats socks a pair goes in and only one comes out maybe you have a goblet eating magic box

Re: Lost my micro goblet

#4

Re: Lost my micro goblet

Barry

You might want to re-think "suction fit" lids on boxes that you keep your goblets in. Could the lid have created turbulence inside the box when it was removed? And your goblet went...........who knows where?

Re: Lost my micro goblet

#5

If that clear box is plastic,

Gil Jones

and you have a static charge buildup,

the cool little goblet could be magnetically

attached to the inside of the lid where you cannot see it.

Re: Lost my micro goblet

#6

Re: If that clear box is plastic,

john lucas

Gil They do get stuck to the side. You can move them around with your finger from the outside. It's pretty cool.

Re: Lost my micro goblet

#7

X-Ray your lungs!

Jorge Casta�eda

told ya not to breathe

Re: Lost my micro goblet

#8

Re: Lost my micro goblet

Dave Gelnett

My first attempt at turning a small top with a skew was eaten by my dog. It was not as small as your goblet but was just big enough for me to get my fat fingers on it to make it spin. I was showing someone when it went off the edge of the table to the floor. Anything which touches the floor the dog thinks it is food.

Yes the dog eat my work.

Re: Lost my micro goblet

#9

I must admit.....

Galen Vetterick

John, I copied the picture of your micro goblet and it may have have gotten stuck to some of the pixels and I took it in error.

I can send you back the pixels. Here it is

Re: Lost my micro goblet

#10

Thanks Galen- now how to I get in the cube 

John Lucas