Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Roughing gouge

Posts

Roughing gouge

#1

Roughing gouge

Clyde Collier

Bought a new gough and was wondering what is the preferred bevel angle. Mine is groung at 30 degrees above horizontal. Thanks

Re: Roughing gouge

#2

Re: Roughing gouge

Terry Gerros

I grind my SRG at 40 degrees. Cuts very nicely.

Re: Roughing gouge

#3

Re: Roughing gouge

John Lucas

I also grind mine sharp about 40 tto 45 or so. I depends on how you use a roughing gouge. If all you are using it for is taking things from rough to round then an angle like 60 ot 80 is better. It will hold a somewhat dull edge for a long time. ONe of the men who showed me how to turn sharpened his this way because he turned hundreds of spindles and didn't want to waste time sharpening that tool.

I rough shape with the tool and then fine tune the shape using the upper part of the U like little skews. consequently I like having mine a lot sharper so I can go right from there to the skew for the final few passes.

Re: Roughing gouge

#4

Re: Roughing gouge

Terry Scott

Johns advice is spot on

Re: Roughing gouge

#5

Re:Let's not forget that ......

JamieDonaldson

...it is a SPINDLE roughing gouge, and I grind mine to approximately 45 degrees. :D

Re: Roughing gouge

#6

Jamie's right- would not recommend using it

John Lucas

for bowls. They simply weren't designed for that and I have seen an awful lot of them bent or broken by people using them to rough out bowls. Better to get a 5/8" bowl gouge for that.

Re: Roughing gouge

#7

Re: Jamie's right- would not recommend using it

Clyde Collier

Thanks,40-45 degrees it is.

Re: Roughing gouge

#8

Steven Antonucci

Geometry problem

steven antonucci

The sharper the edge, the lower you have to hold the handle to be on bevel...

Grind it to an angle that is comfortable and compatible with how you stand at the lathe...

S

Re: Roughing gouge

#9

Re: Geometry problem

Gordon Seto

Raising the tool rest height would compensate for the bevel angle.

Re: Roughing gouge

#10

Re: Geometry problem

john lucas

I agree with Gordon. Both of you are correct to some degree. Raising the tool may change where your cutting on the piece but does change where the handle will fall on your body. As someone who does almost all my turning using my hips to control the cut I move the tool rest a lot. Steve is of course correct also because changing the angle of the bevel changes where the handle will be in relation to the axis of the piece.

Re: Roughing gouge

#11

Re: Geometry problem

Gordon Seto

We are talking SRG here, it is spindle turning. For a bevel supported cut, the cutting is always at the tangent of the spindle and the bevel. The cutting point may change in relationship to the index of the lathe axis, but it doesn't matter because it is a circle. When the diameter gets smaller, we have to raise the end of handle or lower the tool rest height. We may choose to adjust the tool rest height after moving it closer.

When I change tool of different nose angle, I can adjust the tool rest to allow the end of the handle to fall to the same height. Is my assumption right? Otherwise guys with high waist line would prefer to use tools with larger included angle.

Gordon