Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Thickness of blank needed for platter?

Posts

Thickness of blank needed for platter?

#1

Thickness of blank needed for platter?

Henry (Raleigh, NC)

A non-WW friend passed along two pieces - one is purpleheart and he thinks the other is Koa. Each is at least 10" wide and longer than that; one exactly an inch and the other is over 15/16"

I am not experienced with platters of any size but have recently acquired a scroll chuck.

Are these pieces thick enough to consider making platters?

Any other ideas for turning these?

Henry

Re: Thickness of blank needed for platter?

#2

Rob Wallace

Re: Thickness of blank needed for platter?

Rob Wallace

I think I'd use a glue block to maximize use of the full thickness of the wood. You should be able to get a platter out of a 1" thick blank...

Rob

Re: Thickness of blank needed for platter?

#3

Re: Thickness of blank needed for platter?

Henry (Raleigh, NC)

Thanks Rob - I had forgotten that strategy.

I'll definitely try that

Re: Thickness of blank needed for platter?

#4

Re: Thickness of blank needed for platter?

john lucas

I turn a lot of them from 3/4" stock. They are flatter than I would really like but they do sell. I do like Rob suggested on a lot of them. On an 11 1/2" platter I will glue a 6" block to the back. Then use this for the bottom. Quite often I will glue in a thin piece of veneer to accent the glue joint because you really can't hide it.