Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Live Center and Mandrel saver

Posts

Live Center and Mandrel saver

#1

Live Center and Mandrel saver

Dave Gelnett


A few weeks ago there was a thread about Live Centers and Mandrel saver. John Lucas mentioned that would be easy to make something and attach it to a live center. John you inspired me to make one. Here it is. All I did was get a � x 10 nut (which fits my live center) epoxy it to a some wood. Turned it and then used a Jacobs chuck to drill a hole in center. Went to Lowes and got a � x 3/8 steel spacer and aligned it in the center of the wood by way of the mandrel. I also added a 7m bushing to the end to make sure there is no movement.

The spacer is placed so it just touches the live center so that when applying pressure to the bushings it will not slip. Project cost less than $3.

Thanks John this project kept me out of trouble for a short period of time.

Re: Live Center and Mandrel saver

#2

Coool

john lucas

Re: Live Center and Mandrel saver

#3

Re: Live Center and Mandrel saver

Galen Vetterick

Dave

Thanks for posting your live center adapter from John's input.

I just used a friends purchased live center from PSI for the pen mandrel saver but it sure seemed to have a loose fit hole. I got vibration when turning pens.

I made up a few of these center points from hard maple some time back to apply tailstock pressure when I needed.

Don't see why I could not use one and drill and install a 7mm bushing.

Not sure which idea would be best but I got the taper plugs and bushing.

The nut may be easier to remove than a knock out rod on my center plug.

I'll keep this idea in mind if mine fails.

Re: Live Center and Mandrel saver

#4

Dick Hines

Re: Live Center and Mandrel saver

Dick Hines

And what is this thing used for?

Re: Live Center and Mandrel saver

#5

Re: Live Center and Mandrel saver

Dave Gelnett

It is an adaptor which attaches to a live center. The adaptor has a 7 mm bushing in the middle which lets the tail stock slide over a 7 mm mandrel. So instead of putting presser on the end of a mandrel this adaptor will put presser on the bushings and pen blanks. It is suppose to help prevent bowing the mandrel causing the pen to be out of round.

Re: Live Center and Mandrel saver

#6

Dick Hines

Re: Live Center and Mandrel saver

Dick Hines

Got you

Re: Live Center and Mandrel saver

#7

Re: Live Center and Mandrel saver

Starry S Chan

I have problem understanding the value of the "mandrel saver".

The pen blanks are held tight against the bushings by the knurled nut at the tail stock end of the pen mandrel. The mandrel only needs to be held against the live center tight enough so that the mandrel can spin securely. Why do the turner need to turn the live center in so hard that the mandrel may bend.

BTW, I have two cone live centers, a Nova live center and a PSI large 60-degree cone center. The Nova live center is not 60-degree. Does the cone shape matter? It seems that as long as the opening end of mandrel sits perfectly on the cone of the live center, the cone shape should not matter. Am I correct?

Starry Chan

Re: Live Center and Mandrel saver

#8

Re: Live Center and Mandrel saver

Howard Norman

A neighbor/friend who is starting out turning bought a mandrel saver from Penn State. I think he said the price was about $15. It works.