Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Lathe l- ong

Posts

Lathe l- ong

#1

Lathe l- ong

Don at Central Illinois

I sheepishly announce I found the problem with my Delta 46-700. I had asked for help and received a lot of helpful information, none related to what I found. I checked the run out and it was near zero but when I put on a HF it was out of round. Bearings OK, etc. The head stock had loosened a bit and caused enough wobble but only when I had a hunk of wood on it. Fixed now, just something to keep in the back of ones mind for future reference. Again, thanks for all of the helpful info offered.

Re: Lathe l- ong

#2

Leo Cuellar

Re: Lathe l- ong

Leo Cuellar

Hi Don. I was right behind you on thinking I need a new lathe also. But last night I noticed some issues that might be correctable. My tool rest which is actually fairly massive is deflecting! I'm pretty sure it is at the shaft interface. I need to re-level my lathe once I drag it back to the other side of the shop. Then I'll bolt it to the floor. I was experimenting with some new grinds on a skew and actually got a surface that 600 grit dulled up. The problem is that it was wavy! I had to go back to 220 grit to take the ripples out. My chuck is junk and needs to be replaced, the perils of cheaping out. I know my stance and technique need more work too... good thing the practice is so much fun :D

Leo