Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Sliding Dovetails

Posts

Sliding Dovetails

#1

Sliding Dovetails

RPE

I got some inspiration from all these "Bowl from a Board" postings. I want to join my boards using a sliding dovetail as shown in one of the links.

I need to know if there is some trick to it or is it just trial and error to get the fit, and level (face of boards) of the joint. It is easy to make the way down the center of the edge of the board, but to cut the tail in the center of the other board (at the proper width) is a different story. To center the tail you have to cut both sides of it or it will be offset (during the refining process of the fit). So is there a trick or do you just try to get it as close as you can and then run it through the planer until it is flat?

Thanks

RP

Re: Sliding Dovetails

#2

Ken Vaughan

Re: Sliding Dovetails - router table

Ken Vaughan

Router table is the easy way -

I run a straight bit to rough the opening (not wider than the opening desired as the edge. Route two passes with first the top and then the botton sides to center the "dado"

Pick the router bit for angle desired, approximate the location and with the fence well locked down run the socket board twice through the same way to machine the socket.

I then reset the fence and start with a close approximation to route the male part using a scrap board. Route both sides and adjust the fence to sneak up on a good fit -- route the selected board on both sides and after a dry fit check, glue it up.

Re: Sliding Dovetails

#3

Re: Sliding Dovetails - router table

john lucas

Roughly the same as Ken. I route through the middle as close as I can with the Dovetail bit. The put the opposite face of the board against the fence and do it again. This centers the dovetail slot.

To do the outside cuts to make what I'll call the Male dovetail. I just sneak up on it running each side of the board through the router table. I adjust the fence in very small increments.

We should say that the boards must be perfectly flat. Mine weren't and it caused some problems.

Gluing the ring halves together was challenging if you do the bandsaw trick of cutting the board in half and then cutting the rings. It takes a little care to get the dovetails aligned after you apply the glue. Do a test run.

Re: Sliding Dovetails

#4

Leo Cuellar

I liked that link to Bob Hamilton too...

Leo Cuellar

The dovetail revealed at the bottom on the inside of the bowl is what intrigued me. I'm thinking that would look really cool as knobs for a tool chest or chest of drawers. Its gonna be about another week before I can dig my router table out of the back of the shop though. >(