Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Steel Bar

Posts

Steel Bar

#1

Steel Bar

Dave Gelnett

What type of steel bar should I get to use to attach a carbide tip to and then mount in a handle I have?

I saw at Home Depot had some round zinc plated steel and also some black welder steel. Would either of these work or would it be better to go with something else.

Thanks

Re: Steel Bar

#2

Steven Antonucci

Either one is fine

steven antonucci

If you are not planning on brazing it. I wouldn't heat anything with zinc coating (galvanized) for fear of releasing the zinc into fumes and the potentially hazardous things that can occur.

Instead, tap a screw and you are fine.

S

Re: Steel Bar

#3

Re: Steel Bar

Matt Birchfield

I've always been advised to use non-hardened carbon steel for this type of application. It's inexpensive and readily available. Plating is great to prevent rust, but that's all you get for the extra money. I find that sand-blasting the less expensive bar stock and rubbing it with oil (VERY IN-frequently) keeps rust from from forming even when turning oak and walnut. It's also easy to drill and tap for set screws.

Re: Steel Bar

#4

Dick Hines

Re: Steel Bar

Dick Hines

I have a bar like that. I just drilled a hole in the end and CA glued in the tip. When it wore out I just heated the rod enough for the CA to let go and replace the tip.

1/2" bar will just right for a 1/4" itip.

I use the bar to open up the center of my hollow forms.

Re: Steel Bar

#5

Re: Steel Bar

john lucas

Dave any type of bar will work. I don't use drill rod for this because it's too expensive and you don't need high carbon steel for a project like this. I just go to the hardware and buy what they have. I prefer a more polished steel if they have it because it requires less work on my part to make it slide well on the tool rest. I also like the look.

I use 3/16" HSS square cutters. They fit almost perfectly in 1/4" holes. I like to glue them in because the set screws get in the way. If you put them on the top they fill with sawdust so you have to clean them out everytime you need them. If you put them in the bottom you have to lift them over the tool rest everytime you insert the tool into the turning. Put them on the side and you tear up the lip of the vessel. On really big bars I do use set screws because it makes the tool easier to sharpen. On smaller tools I just glue the cutter in with CA. It comes out quite easily with heat.

1/2" bars get me about 6" to 7" deep. 5/8" bars go about 8" to 10" and 3/4" bars go 12" to 14" You can go deeper with any of them if you take really light cuts and can accept the chatter. People who hollow all the time probably have the skills to go deeper with each tool. I can't as of yet.

Re: Steel Bar

#6

Lyle Jamieson

Re: Steel Bar

Lyle Jamieson

Go to your local small welding shop and get some cold rolled steel,. Its cheap and available. While you are at it get a few different diameter sizes.