Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Price drop on over 1300 Rockler items

general 260 VS

Posts

general 260 VS

#1

general 260 VS

Hugh Widdup

what is the length of the V belt on this lathe? i want to replace it, and may do the bearings at the same time, the lathe is about 8 yrs old.

thanks in advance for any information

Re: general 260 VS

#2

Re: general 260 VS

Bill Howatt

my General 26020 20" electronic variable-speed lathe's manual says it is an A82 belt. An A82 belt is 84" long outer circumference according to a Googled site so it sounds about right.

I just looked and my belt is stamped: Jason Uni-match A82.

I have heard of people using Link belts to avoid taking out the spindle. Cut off the old one and snap the Link belt together.

Bill

Re: general 260 VS

#3

Bill's got a point

Ruth Niles

If I had to replace the belt on my General 260, I would definitely go with the link rather than take the whole head stock apart.........again!

Why do you think you have to replace the bearings?

That is just not fun, trust me.

Re: general 260 VS

#4

Re: Bill's got a point

Hugh Widdup

i was thinking if i had to move the shaft to change the belt i would have access to replace the bearings as a preventitive measure.....if it is difficult i will look into the link belt, that would make it a lot easier. now to find the link belt near here (Hamilton On.)

Re: general 260 VS

#5

Re: Bill's got a point

John Veerkamp

Mail order link belt.

Re: general 260 VS

#6

Re: Bill's got a point

Bill Howatt

Busy Bee sells 1/2" link belt which is what I think you need but please verify. It isn't cheap but Busy Bee sells it for about $1 less per foot than Lee Valley.

You can also try industrial belt suppliers but my guess is that BB will be about the best price you can find locally. I think the brand name is actually Power-Twist but there are probably others.

Bill

Re: general 260 VS

#7

Steve Kubien

Send Ruth a plane ticket.

Steve Kubien

Busy Bee or Lee Valley for the link belt. On the other hand, IF you decide to remove the spindle and replace the bearings, get Ruth up here first. Don't bother talking to General, get Ruth and tell her to bring her big wrench. :)

(Ruth, you know I love ya, right? Ruth? Ruth? Hey, is this thing on?)