Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Spiralling tools

Posts

Spiralling tools

#1

Steve Kubien

Spiralling tools

Steve Kubien

Hey folks,

Today I picked up a mini spiralling tool by Gladstone. I get that by tilting the wheel I can space the grooves differently and in different directions but what I am wondering is...

-what sort of speed should the lathe be, let's say for a 12" salad bowl?

-are some woods better or worse for this tool? Specifically I am talking domestic, found wood like maple, cherry, walnut, ash etc etc?

-where do I position the tool, relative to the centre-line of the lathe? Above or below centre or even at centre?

I was hacking up a piece of ash and a piece of Norway maple, both dry and made quite a mess. Not even close to going near a decent piece.

Thanks!

Steve

Re: Spiralling tools

#2

Re: Spiralling tools

Don Orr

If it's anything like the Sorby mini spiral tool that I have, the recommended speed is kind of slow-around 500 rpm. Cut below center. I believe the larger Sorby tool works the same way.

Re: Spiralling tools

#3

Richard Allen

Re: Spiralling tools

Richard Allen

The size of the sprocket and number of teeth on the sprocket determine the size of the spiral. The angle determines the direction of the spiral and the angle of the spiral. Hard fine grain woods work best. It takes several passes to make the spiral so having a fixture to maintain an angle for the tool is important.

There is some skill involved in making spirals. You should practice on 2" diameter spindles before working on a bowl. You can make a spiral on a 2" piece, turn the spiral off and make new spiral on the now 1 1/2" pieces...

Slow is the desired speed. For the 2" spindle 500 rpm is desired. For a 6" bowl the speed should be reduced to 200 RPM.

There are videos on the internet for the Sorby spiral tool.

Re: Spiralling tools

#4

Steve Kubien

Re: Spiralling tools

Steve Kubien

Thanks gentlemen. I'll have at it later tonight. Richard, I will check out the videos you mentioned.

Re: Spiralling tools

#5

Mike Peace

Re: Spiralling tools

Mike Peace

Sorby has a couple of videos on their web site on spiraling and texturing you many want to look at.