Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Carved vessel continued

Posts

Carved vessel continued

#1

Steven Antonucci

Carved vessel continued

steven antonucci

So the first photo showed the beginnings of the carving, with about 3/4 of the carving to still be done. A buddy of mine was over yesterday, and insisted that I had turned the form and then attached the other piece before patinating. I assure you that this is all one piece of wood.


Next to the piece is Frog Tape, which is supposed to create a sharp line and prevent bleed by turning the liquid into a gel. The adhesive has some kind of chemicals in it. Unfortunately, the wood sucked in some of the patina chemicals harder than the tape did, and I've been trying to bleach them out. I have to try lemon juice to see if it works better than Kleenstrip.

The rim was burned with my Priddle style pen, and took about 30 minutes and a million little dots. Final sanding (after the stains are out) is all that remains. Starting to like the idea of bleaching the bottom though...

Comments welcome.

Steve

Re: Carved vessel continued

#2

Re: Carved vessel continued

Carole Valentine

Well, I now know not to use Frog Tape...I had bought a roll with a masking on a turning in mind!

Re: Carved vessel continued

#3

Steven Antonucci

Sorry- not what I meant!

steven antonucci

I have use it successfully before with "thicker' mediums like gesso and sizing for leaf. I think if you seal the wood, it may even work for the thinner liquids like the patina chemicals, but they wick so hard that the frog tape has a no chance to gel them.

Depending upon what you intend to use, I would definitely try the frog tape on a scrap first just to see if it is a good application.

S