Finish suggestions
karl jr
Anyone have suggestions for a finish to use on an end grain vase thingee?
Thanks,
KTK
Knowledge You Can Build On — Est. 1998
Finish suggestions
karl jr
Anyone have suggestions for a finish to use on an end grain vase thingee?
Thanks,
KTK
Re: Finish suggestions
Fred Holder
I use Walnut Oil (Actually the Mahoney Utility Finish) on most things. It dries fairly well and soaks into the wood. After it dries, it also may be buffed with one of the buffing systems (Beal or Don Pencil) both work well. If I don't want an oil finish, I like Kerf's Wood Creme paste wax. It will not buff to a high shine, but it buffs to a soft sheen. Either will work on your endgrain thingee>
Read Rus's Corner in Articles Section..
david
That can be found in the upper left corner of your computer viewing window. Sound advice on finishes from top to bottom.
Re: Finish suggestions
Barry L Elder
How about a picture? Big differences in different woods.
birch pieces needing finish
karl jr
Here's two shots of one of the end grain pieces I've been talking about lately. It's got a couple of coats of danish oil.

This is a picture of two other HF's without any finish. I want to highlight the streaking and redness of these two. That's why I've been asking for suggestions here. I tried water based poly and rattle-can lacquer on another piece and didn't get the effect I was looking for, but the lacquer came close.

Just for the fun of it, here's a b&w shot. I think it needs more contrast.

KTK
Re: birch pieces needing finish
Steve Kubien
3 words
dan
ish
oil
I've used Watco natural with great success on birch like you've got. I really like the results.