Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

Lathe Question

Posts

Lathe Question

#1

Lathe Question

Paul Storck

Recently, I received an old lathe with no motor or drive shaft pulley and of course no manual. I found a motor that turns at 1725 rpm's and I can put pulley's on both the motor and drive shaft. My question is, what is the optimum speed for turning medium stock for a table leg, rolling pin etc. I can back into the correct pulley size if I know how fast the shaft should turn.

Re: Lathe Question

#2

JL

Re: Lathe Question

JL

The answer is - it depends. I would get two stepped pulleys. That way you can vary your speed.

I typically rough turn legs at anywhere from 900 - 2000 rpm. (Variable speed is wonderful.) I might finish turn from 800-1700 rpm. I might sand at 1000-2500 rpm.

As I said - with two stepped pulleys - say about 4-5 steps - you could vary the speed by a reasonable amount. I would want the lowest speed to be maybe 300-500 rpm and the highest speed to be ~2500 rpm.

Re: Lathe Question

#3

Re: Lathe Question

Ron Brown

There is a formula (isn't there always?).

DXRPM= 6,000 to 9,000

Diameter in inches of the workpiece Times RPM should give you a product of between 6,000 and 9,000.

Example for a bowl:

Diameter = 10 inches

RPM = 600

Product is 10X600=6,000 This is the slowest you should turn the bowl (assuming it is balanced)

10X900=9,000 the fastest safe speed. (Although I turn faster)

This formula is widely used and was made popular by Dale Nish from Craft Supplies.

For a 3 inch diameter table leg, Algebra indicates 6,000/3= 2,000 to 9,000/3= 3,000 RPM.

Thus the need for multistepped pulleys.

Good Luck.

Re: Lathe Question

#4

Re: Lathe Question

R Payne

For a long time I had and old lathe (it's still around here). The drive center attached directly to the shaft of a single speed motor. The motor was old enough it had oil ports (not grease fittings). The speed on the motor, if memory serves, was 1150 or so. And I think the motor is 1/4 horse.

It's stuck under a bench. I retired it when it started popping and sparking on start up. I didn't take it apart but figured it finally reached the point insulation was coming off the wiring.

You can do a lot with just a single speed.

ron

Re: Lathe Question

#5

Re: Follow-up Lathe Question

Paul Storck

I want to thank you guys for your responses. It looks like I have a wide range of speeds to use for various projects to choose from. This is a good starting point.

At the moment I'm looking for a 2 or 3 step pulley. Found one on line from MASKA. Any other suggestions as to where I might pick one up?