12TPI vs 20TPI
john lucas
I wanted to know the difference thread pitch makes in the time it takes to cut a thread. Of course a larger thread moves faster than a fine thread but I wanted to know how that affects hand chasing at slow speeds on the lathe. Mostly because a lot of lathes cannot go below 500 rpm.
I ran the lathe at 240rpm and chased threads on a PVC spindle that was 3/4" in diameter. I ran the threads 1 1/4". The 12TPI took 3 seconds to travel the distance and the 20TPI took 6.
What this tells me that when you are cutting only 3 to 6 threads the time it takes is about 1/2 second for the 20 and 1 second for the 12. That's not a lot of difference so for all practical purposes they are about the same.
Technically if your lathe won't slow down the finer thread might give you little more time than the course thread but it's probably more about your skill at chasing than it is about the thread pitch.
The slowest speed on Little Vic is 640 rpm (based on the Vicmarc speeds with a 1140 rpm motor, and my lathe with a 1725 rpm motor). I had a tool to make 20 tpi, I think. It took a lot of wasted wood, but I finally got some usable threads on the inside of a little box... I never got any on the lid.



