Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

steady rest question

Posts

steady rest question

#1

steady rest question

Paul Zerjay

I hope I can describe this correctly. I have a rather large hollow form made from a whole log with the pith centered. The log had some bark inclusions, which I want to keep, and I also wanted to have a contrast in color, so I kept some of the sapwood. Leaving the sapwood meant that the bark inclusions were in tact as well. Now I want to clean up the inside, but my steady rest doesn't seem to want to cooperate. It kinda "clunks" every time it hits one of the inclusions. The inclusions are long enough to not allow moving the steady so it wouldn't run over them. Filling the inclusions with custom fitted pieces of scrap wood, and then removing them later, is all I can come up with. That's a lot of time consuming fitting of pieces. Any other ideas? TIA

Re: steady rest question

#2

Re: steady rest question

Barry Irby

since I don't won a steady rest and have never used one, this is a wild guess.

How about turning a ring maybe out of plywood to put around the HF, stick it on with some hot glue and run the wheels on that?

Re: steady rest question

#3

Re: steady rest question

john lucas

Barry nailed it. I did that with a square piece once. I mounted a piece of plywood with a square hole in it and turned that round. Then I put the steady rest on that. I was able to hollow the square piece without chatter. You could hot glue a ring to the form and put the steady rest on that.

Re: steady rest question

#4

Re: steady rest question

Terry Scott

Turn a ring of 20mm ply fit it over the hollow form attach with some hot melt glue true up the outside of the ring then run the wheels on that

A grove in the ply ring makes it easer as well

Re: steady rest question

#5

Woo Hoo Thanks guys

Paul Zerjay

I can't believe I didn't think of that as I have used the exact same technique last fall. I think I even know where I hung that ring on the wall. What do they call that... a brain fart?

Re: steady rest question

#6

Don Geiger

More on the subject of rings

Don Geiger

I've made several rings for this purpose. I use MDF and hot glue the ring in place. Then turn the ring to true it up and then set up the steady rest.

I've also done this on naturnal edges bowls or ones that have voids along the edge. It helps to keep the bowl from flying apart and keeps it from vibrating when holowing it out.

You don't need to much hot glue. Just spots here and there works fine.

Don Geiger

Re: steady rest question

#7

Re: More on the subject of rings

Paul Zerjay

I thought a pic of the piece in question might show more of what I was talking about. My tallest HF yet.