Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

Bandsaw Dust Collection

Posts

Bandsaw Dust Collection

#1

Bandsaw Dust Collection

Steve Criscenzo

This is in response to the recent thread about bandsaw dust collection. I have a 30 year old 14" Delta with riser blocks. For years I used an attachement I got with the saw for dust collection. It was a sheet metal fitting that bolted onto the saw. It had a 5" port and did a poor job.

Looking at the saw I realized that I need to collect dust both at the point of cut and also at the bottom of the lower wheel.

As shown in the photos, I installed a 4"x3"x3" Y fitting comming from the DC. I them ran two 3" lines to the saw, the first commecting to a wood frame up near the table and the second in a hole cut into the bottom of the lower wheel cover. (I turned a hole into the chuck of plastic for the hose to fit into. It is a friction fit so I can take the hose off to change blades.

The system works well but I may add the brush to the lower wheel that was suggested.

I can provide more detail if anyone is interested

Steve


Re: Bandsaw Dust Collection

#2

Re: Bandsaw Dust Collection

john lopez

I have a newer Delta & have been trying to come up with better dust control.

Yours looks like a good solution.

It will be interesting to see how others respond.

Thanks for posting.

J.L.

Re: Bandsaw Dust Collection

#3

Re: Bandsaw Dust Collection

jared

I likewise have an old delta bandsaw. I just have a 4 in flex pipe running up to the bottem side of the table and held in place with a piece of wire.

This allows for easy removall when I need to change blades, etc. I cut away some of the pipe on the inside closest to where the blade comes out of the bottem of the table to create a dust port. I also put some foam weather strip on the other side of the blade to cut down the suction loss there. While it does not pick up all of the dust there is a very noticeable difference in how much dust is floating around in the air and what collects in the bottem of the lower wheel cavity when I turn on the dust collector. Cheap simple and easy, maybe should be called crude but effective. Jared

Re: Bandsaw Dust Collection

#4

Roger in MO

Re: Bandsaw Dust Collection

Roger in MO

There were several ideas on 4/28/10. I tried the duct tape on the return blade channel and that helped. A shop vac helped but like was said, it too noisy and in the way. I put some foam around the opening at the bottom of the return blade channel and that helped. I plan to hook up to my system, possibly with a second port on the bottom door. Roger