Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

Guess the size

Posts

Guess the size

#1

Guess the size 

Tery Scott

Well Ive had to finally put my turning on the books so to save some tax I had to get a few more toys to balance the ledger (my excuse anyway )

I had a few Kelton bits missing in my stable so this piece is the first real fun since their arrival

This is made from Oak

They say that a good form shown in a picture if right you wont know the size

I am not sure if this comes into that category but have a guess at its size anyway

Turned wet so I shall see what happens as it dries before I decide how to carve chop or texture it

Cheers

Re: Guess the size

#2

Bill Blasic

Re: Guess the size

Bill Blasic

Terry,

It measures 4" wide by 6" tall on my screen :D :D

Bill

Re: Guess the size

#4

Re: Guess the size

Bill Noce Northeast Ohio

6 1/2" wide x 7 1/2" tall on my screen.

Re: Guess the size

#5

Re: Guess the size

518 392-7769

I'm going with Ken on this one - based on the size of the chips on which it rests.

Re: Guess the size

#6

Re: Guess the size

Carole Valentine

177mm x 127mm

Going by the grain and the chips, but probably way off!

Re: Guess the size

#7

Steven Antonucci

Inch +/- tall

Steven Antonucci

Re: Guess the size

#8

Steve Kubien

Re: Guess the size

Steve Kubien

3" tall, width is tough to tell from this angle but around 2", maybe a little less. This is based on the opening, which I figure was made to accomodate the mini Kelton hollowers. Am I close? What do I win?

Re: Guess the size

#9

Chuck Jones - West TN

61mm x 44mm

Chuck Jones - West TN

Re: Guess the size

#10

Re: Guess the size

Matt Overton

judging by the growth rings, and estimating them at 1.5mm. I'm going with 75mm w x 140mm h

Re: Guess the size

#11

3" x 4" high  ( 75mm x 100mm)

jake Niedling

Re: Guess the size

#12

Re: Guess the size 

Tery Scott



18inches 380mm high the width is 10inches 250mm

This picture shows how it was 400 high but when I took it off the lathe and stood up the form was not quite right Luckily I found I had stuffed up the depth / also as deep as my large kelton hollower would reach .

Being so deep was a mission to get a caliper that didn't lie ,I made a wire one as well but couldn't get the angles right so the thickness on the bottom was a guess

Just sitting in the chuck for the photo as I have left on a small 10mm spiggot so I can put back on the lathe if need be later

Re: Guess the size

#13

Steve Kubien

So I guess...

Steve Kubien

...I didn't win anything? Impressive Terry. Very impressive.

Re: Guess the size

#14

Ha!

Jennifer Indy.USA

I thought it was really tiny. Nice form no matter what size it is!

Jen

Re: Guess the size

#15

Re: Guess the size

mike nelson

Very nice Tery, love the top and you fooled us with the chips! ; )