Al Stirt Demo in Vermont 1/17
Brad Vietje
>My local club hosted Al Stirt for an all-day turning, carving and design workshop few weekends ago. We could only afford this sort of event because we meet about a 2-hour drive from where Al lives, so we didn't have to come up with the cost of air fare, hotel & meals. Al just drove over the night before, and stayed with our hosts, Bob & Terry Baker, in Ryegate, VT.
Here's a few pic's of the event..
Here's Al at the oneway lathe discussing grain balance on open bowls
Here Al shows how he makes spiral flues on a small bowl with a sanding drum in the headstock:
Here's a closer view of Al working on a carved piece held in a vacuum carving stand...
And carving a gesso painted platter...
And texturing one of his square edged bowls with a high-speed rotary cutter:
We had about 35 in attendance, a nice lunch, and everyone enjoyed the day.
Safe spinning,
Brad Vietje
Newbury, VT




