Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Rare Exotic & Domestic Hardwoods, Milled In-House in Oregon. Browse Unique Stock.

New tool

Posts

New tool

#1

New tool

john lucas

>I'm making clocks again. I haven't made them in about 4 or 5 years. It's fun but it brought up a problem I had to solve the last time I made them. How to measure the thickness of the face to that your clock would fit and not stick out too much.

I usually just stick something down in the hole and make a mark and the measure it but this was somewhat guesswork. I decided it was time to build a tool. I took a coat hanger and bent it 90 degrees. Then made marks every 1/8". Now it's just a matter of sticking it in the hole and pulling up until it touches the inside. Then I just look at my notches. I can then thin out the outside until it is the exact thickness I need.


img

Re: New tool

#2

Re: New tool in use 

john lucas

>


img

Re: New tool

#3

Roger in MO

Re: New tool

Roger in MO

>Ingenius as usual. If you are looking for an off-the-shelf tool, you might be able to us a machinist "hook rule" which is the same principle. Roger in MO