Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Chainsaw help please...

Posts

Re: Chainsaw help please...

#26

premium gasoline.

John K Jordan

>Many in the industry will not run gasoline with ethanol in small engines regardless of the grade, claiming ethanol not only causes more rapid deterioration of carburetor components but goes "stale" much quicker. It is getting harder to find. If in doubt you can test for ethanol presence and percentage with a $4 kit - I got mine from Bailey's I think.

JKJ

Re: Chainsaw help please...

#27

carl

Re: Chainsaw help please...

carl

>Hi MarC, i have an 025 Sthil. They flood very easy, try to take spark plug out and pull rope with it in the last position several times. It pulls very easy that way. It clears and dries the spark plug chamber.

If that don`t work, take saw and throw it againt tree till all parts are broke, and be pleased that it was a patient man who done that. Carl

Re: Chainsaw help please...

#28

ebd

Re: Chainsaw help please...

ebd

>I read through some of the suggestions but didn't have time for all. If this has been suggested before sorry. My brother had a gas ice auger that had sat for some time. when I checked it everything seemed to be OK. I found though that it wasn't getting fuel to the combustion chamber. I took the gas line off the fuel bowl and tried to blow through it. No flow. I took a battery powered compresser and turned it on and held the outflow tight to the gas line. There was a pop and when I reconnected the gas line it started with no problem. Unless 2 strokes are run dry before long storage you can get clogs because of the oil mix that need to be dislodged before they will start.

Re: Chainsaw help please...

#29

Brad Vietje

Re: Chainsaw help please...

Brad Vietje

>Marc,

I read through each and every reply, and have the following advice: leave it alone for a day or two. Better to get the carb kit, and replace the fuel and filters than getting any more frustrated. You'll have more fun fixing it when you can take a little time and breathe easy.

As one person wrote, it's certainly worth more than $30 for parts, so don't beat the hell out of it, or throw it in a pond!

Good luck!

Brad Vietje

Newbury, VT

Re: Chainsaw help please...

#30

Re: Chainsaw help please...

John K Jordan

>Note that you can sometimes buy a new carb for not much more that the $30 quoted for the rebuild kit. Might check on that first.

A wise man once told me this: if it it has compression, is getting the proper fuel/air, and has a spark at the right time, it HAS to start, it doesn't have any choice.

JKJ

Re: Chainsaw help please...

#31

Keith Tompkins

Re: OK... getting somewhere now... maybe

Keith Tompkins

>Marc, First, plug must be grounded against the engine to create a spark...won't work just plugged in. With the plug out, the engine cannot create vacuum; vacuum is necessary to draw fuel from the carburetor. The ignition is probably solid state, so either it works or it doesn't. 99.9 % chance fuel system is blocked....the saw will idle with a minute amount of fuel, but can't tolerate any opening of throttle...it will stall.