Re: Turning wearing gloves
Scott Crumpton
>Keith, I agree with your concern, but you may be thinking of the thicker high quality nitrile gloves. These things are as thin and nearly as tight as surgical gloves. I've torn holes in them many times doing mechanical work. They keep back grease, oil and finishes, but don't stand up to abrasion or other mechanical stress very well.
But, just to make sure I went down to the shop and put one on. Then grabbed the end of a finger and gave it a quick pull. Tore the finger right off - the glove, not my hand. :-) Did that a couple times, then tried the side of the thumb. The side took more effort to break free, but did.
This was all done using my other hand with no sharp edges to start the tear. There was a good deal of stretch before the breaks (out to about twice the length of the finger). Being skin tight if anything did grab the glove, it would already have grabbed my finger. It would also either pinch or cut the glove starting the tear away.
So, I do agree with your concern but I think that these particular gloves are so easy to tear that if they do add any risk, it's small enough to be acceptable for the benefit that they provide.