Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Sioux drills

Posts

Re: Sioux drills

#26

Re: Sioux drills

Bill Grumbine (Kutztown PA)

>Thanks Randy. I don't know if I use mine more, but mine seems to be leading a charmed life compared to a lot of stories I have heard. Watch now, it will cough up blood and die next week! But I do use it hard, and while I do not doubt the trouble others have had, I wonder if I am doing something different. It certainly is not less sanding per piece. I read about people who start with 180 or 220 grit all the time because their tool technique is so good. I am still using 80 grit to start.

Re: Sioux drills

#27

Re: Sioux drills

Barry Turner

>The drill I use for power sanding is an old Panasonic 9.6 volt cordless. Panasonic does not have cooling vents and is not subject to the dust problem that kills other drills in a short time. This one deserves a look. My drill is at least 15 years old and has been used for power sanding for at least 8 years.

Re: Sioux drills

#28

Jesper, Denmark

Re: Just for the record.....

Jesper, Denmark

>The Sioux and Milwaukee angle drills are the exact same tool, made the same place, but with different colors.

I do not use mine as much as I expect Bill G. does, but it has lasted 10+ years and never set a foot wrong.

I agree with Kathrine about quality and don't throw away atyle tools. There is maybe an alternate quality type of tool for those who have compressed air in the shop. It would seem to me that some of the angle sanders used in the autobody repair industry would work for bowl sanding.

Re: Sioux drills

#29

Re: Just for the record.....

Bill Neddow------WebKitFormBoundary+w+uCg3oRve3I+f

>The angle grinders used in auto body shops will work -- if you slow them down to between 6000 and 8000 rpm. They normally turn at 10,000 to 13000. At the higher speed they will simply burn the wood. The easiest way to slow them down is with a router speed controller (Harbor Freight -- $9 on sale). If you do not lean on the tool (this is the source of heat buildup), you can used your velcro sanding system. I have one grinder set up that way, and the Tim Skilton pad still has its original velcro after several years. Another grinder is set up to use Roloc disks, as they use in the auto body shops. These silicon carbide disks work wonderfully and last a very long time. I also get a better finish using this system.

I have an article on this coming out in the Spring edition of Woodturning Design (on the stands in February, I believe).