Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

bandsaw safety

Posts

Re: bandsaw safety

#26

Re: Vari-grind II

russ fairfield

>Carole, your concern about wearing the wheel is not an argument for not using the new grinding jig. There is a little slop in the jig and there is some room for movement. The wear isn't much different, and I don't have to dress the wheel any more than I do with the conventional Vari-Grind.

Not having to worry about the tool handle taking control and running it off the edge of the wheel more than makes up for any inconvenience. The tendency of a tool with a long and heavy handle to creep out of the socket is also eliminated.

The new jig is not as adaptable as the original Varu-Grind for making frequent changes to meet the needs for different tools. I prefer to set it and leave it in a single setting that works for both bowl and spindle gouges, and use the old jig for the oddball profiles.

Re: bandsaw safety

#27

Re: Vari-grind II

Carole Valentine

>Thanks, Russ. It's good to hear from someone who has actually used the jig. After the mishap the other day, I am pretty sure that even if it did groove the center of the wheel, it would be worth not having that happen again! The only thing I change when grinding my bowl and spindle gouges is the distance from the wheel, so I suppose that would work for me too. As you said, I could still use my old Vari-grind for other stuff.

Re: bandsaw safety

#28

Re:I found that the Vari-grind II did not.....

Jamie Donaldson

>... give me the same profile that I achieve with the original, but if I played with it longer I might be able to replicate the grind I'm using now. It certainly is an improvement for a teaching situation, where people new to a grinder have a much shortened learning curve.

Re: bandsaw safety

#29

Re: Vari-grind II

Ed in Leaside

>"Not having to worry about the tool handle taking control and running it off the edge of the wheel more than makes up for any inconvenience. The tendency of a tool with a long and heavy handle to creep out of the socket is also eliminated."

Here's another solution for those problems. Rotate the entire grinder and arm assembly forward about 55/60 degrees. This gets the tool handle down and out of the way, and the jig stays firmly in the pocket.

Shown using an Ellsworth jig (Varigrind works just as well). The grinder is hanging on a french cleat with the arbor at eye level.


img

Re: bandsaw safety

#30

Kelton Sharpening Sustem

Jorge Castaneda~Downeast Maine

>Carole,

Glad you did not got hurt.

I had a "warning" using the varigrind a couple years ago, too sloppy for me, so I did look around and got the Kelton system. Very substantial and a lot more control, and can take bigger gouges as well. It has a ball at the foot of the jig and that rotates in a matching socket, smooth action, no slop, and besides moving closer or father from the wheel, you can also raise or lower the socket and the jig itself can vary the angle.

This came at the time I started getting tools from Doug Thompson, so another thing I love happened, I make my own handles and put set screws on them, so when sharpening, the handle is on a bench and only the iron goes to the grinder, no more hassle with handles. It takes little time and it is very safe.

If you want I can take pictures tomorrow, let me know.

Jorge

Repect everything, even yourself...