Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Fast and affordable laser cutting – so you can make the parts you can’t find anywhere else

Using a slip stone

Posts

Using a slip stone

#1

Using a slip stone

Marc Phillips

>I just got the slipstones I ordered...

So, the bowl gouge...

I few swipes on the inside, rubbing the slipstone back and forth to remove any burr... then a couple/three swipes on the bevel, keeping the stone in contact (i.e. flat against the bevel) with the tip and heel.

This is what I was able to gather running around the internet...

Is this correct?

Any other tips would sure be appreciated too...

Re: Using a slip stone

#2

Re: Using a slip stone

Harry in Beautiful Downtown Kulpsville

>Sounds right to me. If you do this regularly, you will keep the tool sharp and minimize trips to the grinder. And that should extend the tool life.

Re: Using a slip stone

#3

Re: Using a slip stone

john lucas

>I do it the other way around but I'm not sure it makes a difference. I hone the bevel first ant then the flute. Probably like cutting tails first or pins first on dovetails.