Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Mini lathe with slow speeds

Posts

Re: Mini lathe with slow speeds

#26

Keith Tompkins

Re: Mini lathe with slow speeds

Keith Tompkins

>Johnathan, 500 rpm is fine for drilling....it's the feed rate, that you can control, that will be the most important part. I have the Rikon as well (demo lathe) and it's all the mini-lathe you'll need. VS lathes come with their own set of problems...low torque. Your lathe motor is always at max rpm, thus, full torque.

Re: Mini lathe with slow speeds

#27

Re: Mini lathe with slow speeds

Jeff Willaford

>Just checked my forstner bits and they have 450 rpm max engraved on them but my Jet mini at 500 seems close enough. As Keith said "It's the feed rate". I also run about the same speed on the drill press depending on the size of bit and the hardness of the material. 2" is the largest bit I've used.

Re: Mini lathe with slow speeds

#28

Re: Mini lathe with slow speeds

GalenV in Iowa

>The Delta has reverse that the Jet does not. As long as the chuck does not unscrew. I guess this is a good feature. When you get tired of standing on your feet you can hang upside down and turn in reverse. Hard to keep the tool on the rest though. :>)

Reply from a Jet 1220 owner.