Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Have a question? Ask Woody!

My search for a 6" faceplate

Posts

My search for a 6" faceplate

#1

My search for a 6" faceplate

Andrew Bourke

>Being the owner of the a Nova 1624-44 lathe and wanting to try the full capacity of the lathe I set aside a 16" x 8" blank. My first choice for initial turning would be a 6" faceplate. I only seem to be able to get one from Oneway at $68! The exchange rate for South African rand is R9/$

Does anybody know where I can find a faceplate at a more reasonable cost with a 1 1/4 x 8 tpi thread. Any suggestions would help

Re: My search for a 6" faceplate

#2

Re: My search for a 6" faceplate

Mark Trenier

>My Jet 1642 came with one. Don't know if you have any Jet dealers in the area--check with them.

Re: My search for a 6" faceplate

#3

Steve Kubien

Re: My search for a 6" faceplate *LINK*

Steve Kubien

>Hi Andrew,

I bought my 8" faceplate locally at Busy Bee Tools. I am sure they can ship. Mine is item B1291 and it seems ok. I doubt it is as stiff as a Oneway but it has worked ok for me. Be sure you get the insert for it. B1291 is JUST a faceplate and won't thread on anything.


Busy Bee faceplate

Re: My search for a 6" faceplate

#4

Re: My search for a 6" faceplate

david

>I have a Vicmarc VL300 with a 24 inch swing. Under the category when your eyes are too big for your stomach, I got four 6" faceplates and two 3" faceplates from a guy who basically welded a nut with the correct threads to a disc. Was a long time ago, so can't find the source. Turns out I use the 3" ones a lot more than the 6" ones. Your experience may be different.

Re: My search for a 6" faceplate

#5

Re: My search for a 6" faceplate

Jorge Castaneda~Downeast Maine

>Andrew,

Teknatool makes one, it is cast aluminum and it just does not compares with the Oneway.

My lathe is a Nova 3000, an older version of your ans I have a number of faceplates, 3", 4" an 6" the 4" ones get the more use.

Also, I have faceplate rings, made by Vicmark, an economical solution if you already own a chuck with dovetail in the jaws, the faceplate ring has a matching dovetail and expanding the jaws grabs the ring.

I screw the ring to a glue block and then glu the blank to thr glue block. It is my favorite method to make platters, can make both sides without remounting.

Look around and see who carries them, here in USA, Craft Supplies and Packard carry them.

Good luck

Jorge

Re: My search for a 6" faceplate

#6

Re: My search for a 6" faceplate

mike Nelson

>I am just curious, I haven't used a face-plate in years and when I did I never spent more than twenty bucks to have a nut welded on a plate. I have mentioned before how I mount and turn a tenon on a large blank and haven't heard if anyone uses this technique, I use my large Nova chuck and a morse star drive protruding about an eight of an inch past the jaws with the tail stock pulled up, ballance as close as you can and turn a tenon on the end. I have even turned complete forms this way, just keep tightening the tail occasionally.