Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Identify and use hundreds of woods

New PM3520B has a *tick*

Posts

Re: New PM3520B has a *tick*

#26

Re: New PM3520B has a *tick*

Rich Egan

>Ron:

I had the same problem with mine when it was new. I needed to run it at high speed for 20-30 minutes until the bearing lube warmed up enough to allow one of the bearings to roll over in its race and move off a flat spot. Sound went away, and hasn't been back.

Hope that helps,

Rich

Re: New PM3520B has a *tick*

#27

Re: New PM3520B has a *tick*

Charlie Drake

>Ron, I too have had the dreaded tick (only difference is mine was fine for first 6 months or so than it began to tick). Like you, I tried to troubleshoot to no avail. No tick without tension on belt. Finally, I moved th belt to the high range and no tick. Then moved it back to low range and again, no tick. It's been a few days and still OK but woldn't be surprised if it mysteriously reappears. Who Knows??

Re: New PM3520B has a *tick*

#28

Re: New PM3520B has a *tick*

Ron Solfest

>Thanks for the idea, I ran it for ~1hr this evening on high...unfortunately it did not solve anything. I turned it off and slowly rotated the handwheel expectantly waiting on silence...had the tick/creak in exactly the same position of the motor shaft again.

I sent a message off to PM and will just need to wait for their help I guess.

Re: New PM3520B has a *tick*

#29

Re: New PM3520B has a *tick*

Ron Solfest

>Gary, What parts did they ship you? As you can tell from this string I've tried everything I can think of and now waiting for PM to get back to me. I'm curious what it was in your case?

Thanks,

Ron

Re: New PM3520B has a *tick*

#30

Re: New PM3520B has a *tick*

Gary in Zirconia, NC

>It was the bearings in my case. They said one of the bearings had a chip in it and that was making the noise.

Re: New PM3520B has a *tick*

#31

Re: New PM3520B has a *tick*

RPE

>This is exactally what it is. The pulleys are just barely out of alignment. This causes a click from the ribbed belt. Slight repositioning of the pulleys will eliminate the sound. I had the same thing in my PM3520 and this is how it was fixed. Remove the 1 from the email address

Re: New PM3520B has a *tick*

#32

Re: New PM3520B has a *tick* - FIXED

Ron Solfest

>PM replaced the motor today and the *tick* is now gone :) Thanks for everyone's ideas and suggestions.

Re: New PM3520B has a *tick*

#33

Re: New PM3520B has a *tick* - FIXED

JohnKyler

>If you find out what that tick is I sure would like to know..

Sometimes you never know what causes these little noises.

John