Non Waxed Dental Floss
Stuart Johnson
>Could you soak some dental floss in debonder and then work it between the ways and head stock. It might cut through the CA.
Knowledge You Can Build On — Est. 1998
Non Waxed Dental Floss
Stuart Johnson
>Could you soak some dental floss in debonder and then work it between the ways and head stock. It might cut through the CA.
Re: Non Waxed Dental Floss
Coyne
>There is no question in miy mind. This is the most innovative, helpful, original, sometimes off the wall, wondeful group of people gathered in one message board. If anyone ever has a problem--any kind of problem--he or she can get caring, experienced, sometimes even helpful advice, support, and even phyusicalhelp. What a group!
Coyne
Re: Now I've gone and done it-- #$%&^%*&!!
ebd
>I put acetone into the accelorator dispensor and apray it on thick CA and it sets up instantly?
Re: Non Waxed Dental Floss
eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---
>I ditto what you just said: it's incredible how many of you have given my problem some thought! I'm very thankful. Let me tell you what worked. I got my big 1 1/2 ton car jack in from the garage -- the one with a long lever handle and a dish-shaped lifter that goes under the car. Then I used a board to make up the difference in height from the dish to the end of the lathe motor( I cut a small half circle in the board to fit the motor) and carefully jacked up the headstock. The debonder was flooded on the inboard side earlier. That worked! I still had to affix a big clamp between the headstock and the end of the lathe bed in a horizontal position to slide the headstock because there was still much goop under there. And it took a fair amount of work to get it all cleaned up -- including sliding sheets of paper between the headstock and lathe bed to slide out most of the gunk under there. So thanks to you all again! What a great bunch of people!
Re: Now I've gone and done it-- #$%&^%*&!!
eliot d------WebKitFormBoundaryu+MBDi+0MX0Pf5O9---
>I responded to all with what finally worked and thanked everyone But it turned out that your suggestion,one of the first listed, was the one that worked. So thanks! I didn't use a scissor jack; I used one of those jacks with the long handle and put a board between it and the mortor. I believe John Jordan's suggestion to use a long lever over the tool rest would have worked also. The main point is that applying torque perpendicular to the glued surfaces -- as opposed to parallel to them -- did the trick.
Re: Now I've gone and done it-- #$%&^%*&!!
jfox442
>Glad to hear you are now "unglued" and can continue with your turning.
James