Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Turning Speeds Again.....(Long)

Posts

Re: Turning Speeds Again.....(Long)

#26

Re: Turning Speeds Again.....(Long)

keith zimmerman, Normal IL

>Excellent thread Wally. Everything that was stated makes sense to me. I remember back in 2003 when I first met Bill G. and he was showing us some cuts on a Jet 1236. He turned up the lathe until it started walking and then turned it down.

I still turn bowls and hollow at 1200 on my Jet Mini VS because that is what I am comfortable with.

keithz

Re: Turning Speeds Again.....(Long)

#27

Re: Turning Speeds Again.....(Long)

robo hippy

>Borrowing a quote from Patsfan on Woodnet,"when shpincter tightening exceeds chuck tightening, you have a problem"

That pretty much says it all.

robo hippy

Re: Turning Speeds Again.....(Long)

#28

Re: Hey Bill.....

Bill Grumbine - Kutztown PA

>Wally, I haven't lost anyone yet, at least to them being hit with wood! ;-)

Re: Turning Speeds Again.....(Long)

#29

Re: Since you asked about a 12" salad bowl.......

Russ Fairfield

>If the marks around the speed dial mean anything, I turn a 12" salad bowl, both green and dry, at about 1200 RPM, and sometimes up to 1400-1600 RPM if I am making a finished cut in dry wood. The only reasons I would go slower are unbalance or vibration.

Re: Turning Speeds Again.....(Long)

#30

Re: Hey Bill.....

Ian

>bill, i've been in the front row when you turn one of your banana boat bowls, the chips did make it to the 3 row and some did move but hey that what seperates the men from the boys.

my point is speed is only a factor when you aren't sure what will happen. you turn those at a high speed I turned my first one at a much slower speed. now I can turn them fast with comfort.

wally, if your in the front row plan on brushing off a few chips.

IAN

Re: Turning Speeds Again.....(Long)

#31

It's a judgement call with many variables

Ken Grunke from SW WI

>I like the formula that Doug presented, it is directly related to surface speed which is the bottom line for lathe RPM.

I would start with that multiplier, 6000 to 9000, and divide the diameter where the tool is cutting to get the approximate RPM.

The lower range for out of balance pieces, or for the less experienced turner. Bill Grumbine goes beyond the upper range, so you can follow his lead if you have the experience.

Keep in mind, that multiplier value applies to measuring diameter in inches only. If you use centimeters, or any other unit besides inches, you need to make a conversion. Math is not my strong point so I will leave that up to someone else, and inches are just fine with me.